Automatic remote control one way spike barrier pre-embedded surface mount tyre killer
Easy-to-maintain
Axis: Design for disassembly, make it easy to exchange actuator
Wiring-pipe design
There's "wiring pipe" on each tyre killer. Make it easy to wiring even the power supply is on the opposite side.
| Model | SN-TK02 |
| Height of spikes (Rising) | 120mm (Uni-directional) |
| Thickness of spikes | 10mm |
| Thickness of panel | 12mm |
| Axis | Dia.25mm, 45#steel - solid |
| Actuator | Single |
| Rising time | 1-2s |
| Dropping time | 1-2s |
| Manually rising/dropping | Yes |
| Power supply | 220VAC/ 110VAC |
| Power consumption | 200W~400W |
| Dimension - Length | 2~6m (On request) |
| - Width | 550mm (Uni-directional) |
| - Height (While dropped) | 83mm |
| Color | Yellow/Green/Red |
| Color of reflective tape | Yellow/Black |
| Control center | Spray paint (Outdoor use) |
| Remote control distance | 100m |
| Wire switch | Suport |
| Traffic light linkage control | Support |
1. Firm and anti-collision. The tyre killer body and spikes are made of 10mm thickness standard Q235 carbon steel with strong load-bearing and destructive power.The structure is firm and durable.
2. IP68 military protection standard.
3. Speedy and Low noise.The hydraulic tyre killer is hydraulically powered through both the raise and lower cycles, taking much less time and lower level of noise to operate.Typical operating (opening /closing) time is 1-2 seconds.
4. Safe and Reliable.Single phase drive motor, or a three phase motor to allow very high frequency of operation. This is ideal for large car parks or busy sites. Environment protection, low power consumption and high reliability.
5. Flexible control method, The system support remote control and drive-by-wire typically. For remote control, the controller is available to work 30 meters far away from the blocker device(depends on the radio communication environment on site).
6. Back up solution,Support manual operate mode,the spikes can lift or fall on level place by manual when power-off.
7. Convenient maintenance. It is easy to check, test and fix the problem.
8. Functional and Manageable: Safety accessories like photocells, inductive loop detectors , beam sensor can be integrated to the system very easily.
9. It can be installed with other access control elements (for example bollards, road barrier ,turnstiles,fire alarm system,traffic light) in order to achieve an access control check-point at the highest level of security.
10. Wide range of optional configurations: Can be custom designed to suit your requirements and can be built in an almost infinite range of thickness and length to suit any roadway or level of security.
Product photo
Cases of automatic tire killer
Product Tags:
|
|
Automatic Remote Control Tire Killer One Way Spike Barrier Pre Embedded Surface Mount Images
|
